5 Lighted Grape Cluster String Lights, Indoor-Outdoor, 35 Lights, Plug-in, RED (2024)

FAQs

How do I know how many string lights I need? ›

String Lights

(Don't forget to include enough to reach the outlet.) For columns or trees, measure once around and multiply that by how many times you'll wind your light around. Once you determine the total length, divide that by the length of a single strand for the quantity you'll need to purchase.

The average spacing between sockets on a patio light string is at least 12 inches. However, spacing can range from 12 inches to 3 feet wide.

If you lack an outdoor outlet, You can plug in Christmas lights to an indoor power outlet by using an extension cord, solar, rechargeable batteries, wireless lights, and candles. Lights outdoors usher in a merry Christmas for all.

If working with multiple light strings, finish hanging your first run and then connect the male end of the second string to the female end of the first and continue going in this way until all strings are in place!

You can typically connect 8 to 10 times more LED light strings together end to end while only using one plug outlet. Most traditional Christmas mini lights allow you to connect only 4 or 5 sets end to end, but with many LED mini light strings you can connect 40 to 50+ together depending on the light count.

So, maximum connectivity is calculated by dividing 210 watts by the number of total watts required by the light string you are considering. For example if your light string is rated at 20 watts, then you can run a maximum of 10 strings together in series.

Electric plug-in Christmas lights last for at least 50 hours, even though they can last up to 100 hours depending on how often you use them. The major challenge with electric plug-in Christmas fairy lights is that they consume a lot of electricity.

Usually it's because your string has a break somewhere and the copper has been exposed to moisture. Your next step will be to replace the fuse, but if you do and the new fuse blows immediately, then you have to track down the string of lights that is causing that fuse to blow, and replace it.

How are string lights wired? ›

Series Lights. When lights are attached in series, the electricity passes from the power source to the first light, and then from light to light until it returns to the power source. In this setup, when a filament within any one bulb blows out, it creates an open circuit in the wiring.

It may seem low risk, but it's always better to turn off your Christmas lights before you go to bed at night. "We recommend unplugging your tree before you got to sleep or leave the house," shares Jen Wilbert, AVP of Property at Travelers Insurance.

Lights suitable for indoor use should only be used indoors. This will be indicated on the packaging or on the light itself (usually on a tag near the plug). It's not safe to use indoor lights outdoors as they don't have the additional weatherproof ratings.

The most convenient way to test for faulty bulbs in a light string is through the use of a light tester. Light testers search for the point in the string where the voltage changes between a good bulb with current flowing and a problem area with minimal current.

When it comes to led strips, most of them will come with a female 2.1mm connection point ensuring that the connection is seamless. All you'll need to do is plug in the led strips into your plug-in power supply and you'll have a working led light. The other option is for those using the hardwired power supplies.

Attach the snap hooks on the guide wire to the screw hooks and hang the guide wire across the planned light layout. Tighten the ends using the cable clips to keep the guide wire at a taut length. For a layout in a wheel-spoke pattern, use an open hook in the center that can connect multiple snap hooks and hold tension.

Use guide wire to support the hanging lights if needed. If you are hanging heavy bulbs or running hanging lights about 100 feet or more, we recommend guide wire. It provides extra support for your hanging lights, reducing the tension of the strings.